SCSI Configuration Parameters

SCSI target ID - xx equals target ID, values from 00 to 15 are scrolled

SCSI LUN - LUN number used in SCSI commands, values 0 to 7 are scrolled (0 = default)

Wide negotiation - select if target starts wide negotiations

xxxxx =	dsabl ( disabled ) - target does not start wide negotiations (default)
	enabl ( enabled ) - target starts wide negotiations

Synchronous negotiation - select if target starts synchronous negotiations

xxxxx =	dsabl (disabled) - target doesn’t start synchronous negotiations (default)
	enabl (enabled ) - target starts synchronous negotiations

Transfer Time-out - target goes bus free after no initiator back after 5 minutes

xxxxx =	dsabl ( disabled ) - target does not time-out initiator (default)
	enabl ( enabled ) - target goes bus free after 5 minutes

SCSI state during loading or rewinding, status is either BUSY or CHECK CONDITION

xxxx =	Busy target returns BUSY status during loading, rewinding (default)
	Nrdy ( Not Ready ) target returns "NOT READY" check condition during loading and rewinding

Buffer mode until changed by SCSI Mode Select Command (buff = default)

xxxx =	buff ( buffered mode ) write commands return status after data is in buffer
	off ( non-buffered mode) write commands return status after data is on tape
	sp.3 ( Special Buffer Mode ) Special Buffer Mode from SCSI - not supported

Synchronize buffer, write all data to tape after one, 2 sequential, or buffer all filemarks (buff = default)

xxxxx =	all - write all buffer data to tape after writing one filemark
	2 seq - write all buffer data to tape after receiving 2 sequential write filemarks, single filemarks are buffered
	buff - buffer all filemarks, treat filemarks the same as buffered data

Disconnection time-out - time-out to quit reselection to a disconnected initiator
xx = 0 (no time-out, default) or 5,10,15,20,25,30,35,40 minutes

Maximum number of retries to successfully write data from the buffer to tape
xx - scrolls from 10,15,20, and 25 (10 = default)

Maximum number of retries to successfully read data from the tape into the buffer
xx - scrolls from 10,20,30,40,50,60,70,80,90, and 100 (10 = default)